REAR PANEL
1917
FUSE
DETECTOR LOOPOUTPUTINPUTSOUTPUTDETECTOR LOOPOPERATIP
115~230VT250mAL250VTIP= INPUTTIP/PIN2= INPUTLEVELTINGTIP/PIN2INPUTS
RING= OUTPUT+4dBuRING/PIN3RING= OUTPUT+4dBuRING/PIN3
CAUTION: TO REDUCE THE RISK OF FIRE.SLEEVE = -10dBVOPERALEVELTINGSLEEVE/PIN1SLEEVE = -10dBVSLEEVE/PIN1
REPLACE ONLY WITH THE SAME TYPE AND RATING OF FUSE
ATTENTION: UTILISER UN FUSIBLE DE
RECHANGE DE MEME TYPE
NADY SYSTEMS, INC.AC INPUT
Emeryville, CAMade in China USACH 2CH 1
1820151614
14. INPUTS:
The CL-5000 is equipped with both 1/4" (6.3mm) TRS and XLR audio input jacks. These can be used for either balanced or
unbalanced operation as follows: .
Unbalanced use of mono 1/4" plugs:Tip = Signal, Sleeve = Ground / Shield.
Balanced use of TRS stereo 1/4" plugs:Tip = hot (+), Ring = cold (-), Sleeve = Ground / Shield.
Balanced use with XLR connectors:1 = Ground / Shield, 2 = hot (+), 3 = cold (-).
15. OUTPUTS:
The audio outputs of the CL-5000 are XLR connectors.
Balanced XLR connectors: 1 = Ground / Shield, 2 = hot (+), 3 = cold (-).
16. OPERATING LEVEL Switch:
With the OPERATING LEVEL switch, you can select either of 2 operating levels: the -10 dBV home recording level or the +4 dBu
professional studio level. The level meters are referenced automatically to the selected level so that optimum operating range of
the meters will always be ensured.
17. FUSE HOLDER:
The IEC power socket has an integral fuse holder that takes a 20mm fuse. Always replace a blown fuse with the same type as
specified on the rear of the unit.
18 . POWER CONNECTION:
A standard IEC AC power socket for connecting to the main AC supply with the power cord supplied.
19. AC VOLTAGE SELECTOR Switch:
Use the VOLTAGE SELECTOR Switch to set the unit for the proper voltage for your area, 115 VAC/60 Hz or 230 VAC/50 Hz.
(Note: Selecting the wrong voltage can damage the unt.)
20. DETECTOR LOOP INSERT:
This 1/4" TRS jack can be used as insert point to enable the unit to be controlled externally to operate frequency conscious via
an equalizer. You can use the connector as a pure input (mono jack connector) or as an insert (stereo jack connector). In this
case, use a special insert adapter cable which splits up one stereo into two mono jack connectors. The ring of the DETECTOR
LOOP connector carries the unitOs output signal and the tip receives the processed signal from an external unit.
10 |
ACEC
